INSTRUCTIONS FOR WALL MOUNTING

Preparation: The Dispenser should be applied to a clean, smooth, non-greasy, dry surface and not to unstable surfaces such as flaking paint or wet plaster.

Porous, Powdery or Unpainted Surfaces: Seal first (with varnish or hairspray) and allow to dry.

Freshly Painted Surfaces: Allow at least 4 weeks for paint to cure.

Ceramic Tiles: Clean well with powder cleanser to remove silicone deposit.

• Select and mark a convenient position at least 150cm (5ft) above the floor. Repositioning will reduce adhesion.
• Remove the liner paper from the top and bottom adhesive tapes on the back of the Dispenser.
• Press the Dispenser firmly into position using both thumbs inside the unit directly behind the adhesive tape area.
• Leave Dispenser empty for at least 24 hours before using.
• Place the aerosol can into position by fitting the slender notch in the plastic cap of the aerosol can onto the hook inside the Dispenser.
• Pull the can down slightly to lock it into position.
• A short simple touch...Clean Air is on hand whenever you need it.